The seat must be removable without the need to cut any of the seat belts or remove the harness buckle.
The shoulder and lap belts must fall away over the seat edges as it is withdrawn and the crotch straps must
pass freely through the seat bottom hole or holes, which must be located in front of the driver's crotch.
Any seat liner must have the same holes as the seat shell, identical and perfectly aligned with them in order
to prevent the harness straps being trapped.
However, if the lap straps have to pass through holes in the seat, it is necessary to fit the car with a harness
having the buckle attached to a shoulder belt, given that the buckle will not pass between the driver's body
and the side of the seat.
Any seat made from foam must be covered with a non-flammable and non-combustible material.
To Next Page
