6. On the bottom right corner of the dash will be displayed the message below
During this waiting period the throttle body is commanded by the ECU from full closed to full stroke,
then back to full closed. It is possible to hear it moving.
7. If the pedal learning is completed successfully the dash will display the message below
Power cycle the car: switch OFF and then ON the electric system in order to save the learning
executed.
If the pedal learning is not successful the message below is displayed
In this case, switch off the car and check for possible issues preventing the pedal learning procedure.
Most common causes of failed pedal learning procedures are:
• Main switch in MAIN on condition and not in IGN ON condition.
• Full stroke and rest position of the pedal out of threshold. Switch ON the car and check on the
dashboard page 2 the values Pedal 1 and Pedal 2
• Faulty readings of the pedal position sensor. Switch ON the car and check on the dashboard page 2
the values Pedal 1 and Pedal 2.
To Next Page
