Technoton DUT-E AF - Page 43

DUT-E installation / Monitoring of two and more tanks / DUT-E AF readings totalizing
DUT-E fuel level sensors. Operation manual. Version 8.1
© Technoton, 2020 43
Table 9 — DUT-E SUM AF wires assignment
Wire number
Wire marking
Wire color*
Assignment
1
VBAT
Orange
Power supply “+”
2
GND
Brown
Ground
3
KLIN
Black
K-Line (ISO 14230)
* The Manufacturer reserves the right to change wire colors.
To get correct values DUT-E AF Analog output should be configured with Service DUT-E
software (version 3.22 and higher). Configuration instructions (see 3.10.4):
• when totalizing readings of DUT-E AF in analog output mode select U output signal
type for all sensors. Insert minimum (U
min
, V) and maximum (U
max
, V) signal values
into correspondent fields.
ATTENTION: When totalizing readings of DUT-E AF in frequency output mode select F
parameter value for N
n
sensor from the Output type drop-down list. Select U for
N
1
…N
n-1
sensors.
• select the highest address for N
n
sensor at Settings-Operation modes module.
Select consecutive network addresses for N
1
…N
n-1
sensors without missing
addresses for the best and fastest totalizing performance (see figure 24).
• select Sum parameter value for N
n
sensor from the second drop-down list. Any type
(Level or Volume) can be set for N
1
…N
n-1
sensors.
• exit Service DUT-E since sensor is configured because the software is blocking data
exchange between DUT-E AF.