Tektronix 453 - Page 146

-
,.....,..,
"""""'
,.,,,,
1.
Pull the
intermediate
sec-
ti on
of each slideout track
out
to its
fully extended
position.
2.
Insert
the
chassis
sections
(on instrument)
into
the
intermediate sedions.
3.
Press both stop latches
and
push the instrument into the
rack until the latches snap
into
the
stop latch
holes.
4.
Connect the power
the power source.
5.
Again press
the
stop
latches
and
push
the
in-
strument all
the
way into
the rack.
6.
To secure
the
Type R453
to
the rack,
insert the 4
securing screws
(with
fin-
ishing washers
and teflon
washers) through the slots
in
the instrument
front
panel
and screw them into
the front rails of
the rack.
1. Remove the securing
and washers.
2. Pull the instrument outward
until the stop latches
snap
into the stop latch holes.
3. Disconnect the power cord.
4. Press both stop latches
and
pull the instrument out of
the rack.
Rackmounting-Type 453/R453
!Al
m
{C)
Fig. 6-9. Procedure for inserting or removing the instrument after the slideout tracks have been installed.
©
6-7