Tektronix 453 User Manual

Rackmounting- Type 453/R453
TO ADJUST ALIGNMENT:
1. Position the Instrument with the pivot screws ap-
proximately even with the front rails.
2. Loosen the mounting screws at the front
stationary sections (left side shown I .
3. Allow the tracks to seek their normal positions
with
the instrument centered in the rack.
4. Tighten the mounting screws.
5. Push the instrument all the way into the rack.
If tracks
do not slide smoothly, check for correct
spacing
between the rear supports.
6. Check the vertical positioning of the Type 1453
front panel with respect to adlacent instruments or
panels. If not correct, reposition as necessary.
Fig. 6-10. Alignment adjustments for correct operation. __ _
DEEP RACK CONFIGURATION:
T.~:;,
SHALLOW RACK CONFIGURATION:
BHS
8
_
32
screw
Keps
m
nut t!j
12 ea)
screws
(Al Rear rail
tapped for 10-32 screws
8-32
FHS
screw
~
Stationary
section of
slideout
track
8-32
FHS
screw
'!,;~<l
~~
Stationary
section
of
slideout
track
DEEP RACK CONFIGURATION:
T
1~~~2
screw
(2 ea)
f ::':;;I
Bar
nut
8-32 ~
Keps ,
nut .
(2 ea)
mounti
bracke
SHALLOW RACK CONFIGURATION:
BHS
screw
8-32 ~
.:!,1~~~2~
sere~ I
(Bl Untapped rear rail
(2 ea)
f\:;:-:;::,:t.1
Bar
nut
Fig. 6-11. Alternative method of installing the instrument using rear support brackets.
6-8
8-32
FHS
screw
~
Stationary
section of
slideout
track
8-32
FHS
screw
~
Stationary
section of
slideout
track
@

Tektronix 453 Specifications

General

Brand	Tektronix
Model	453
Category	Test Equipment
Language	English