Tektronix TDS5000B Series - Limit Test for Performance Verification

Commands
TDS5000B Series Service Manual
5-29
DIAg:RESults?
This query-only command returns an abbreviated status about the results of the
last diagnostic (or test) execution. For a more explanatory status message, use
the DIAg:RESults:VERBose query. This command is equivalent to selecting
Instrument Diagnostics from the Utilities menu, and then reviewing the
Diagnostic Status.
This query can be issued while diagnostics are sti l l in progress.
DIAg:RESults:VERBose?
DIAg:RESults?
DIAg:RESults?
This query might return
:DIAG:RESULTS “135”
indicating the specific failure code of the first test failure that occurred.
DIAG:RESults?
This query might return
:DIAG:RESULTS “Pass”
indicating the specific failure code of the first test failure that occurred.
DIAG:RESults?
This query might return
:DIAg:RESults “*****”
indicating the diagnostic test was not run.
DIAg:RESults:VERBose?
This query-only command returns a more explanatory message about the results
of the last diagnostic (or test) execution that the DIAg:RESults? query. This
command is equivalent to selecting Instrument Diagnostics from the Utilities
menu, and then reviewing the Diagnostic Status.
This query can be issued while diagnostics are sti l l in progress.
Related Commands
Syntax
Example 1
Example 2
Example 3