SYSTEM MAINTENANCE AND SOFTWARE UPDATE
CHAPTER 7
106
ECOTEL 3G 16.1. Revised: 1 March 2011.
Example: In the following example, the DynDNS service is used and the domain name is
host.domain.de; the username is user and the password is pwd. The ECOTEL works as
DSL router and the dynamically allocated IP address of the PPPoE interface is used:
dhs
dyndns
dyndns-static
dyns
ezip
easydns
easydns-partner
gnudip
heipv6tb
hn
pgpow
ods
tzo
zoneedit
http://www.dhs.org
http://www.dyndns.org
http://www.dyns.cx
http://www.ez-ip.net
http:/www.easydns.com
http://www.gnudip.cheapnet.net
http://www.hn.org
http:www.justlinux.com
http://ods.org
http://www.tzo.com
http://zoneedit.com
user=<username:password>
Defines the username and password for the DNS service provider.
host=<domain_name_of_dns_service>
Enter the domain name that is used.
interface=<If>
Defines the interface to be used. Possible entries are
emac0, emac1, pppoe0. The dynamic IP address for
this interface is transmitted to the service provider.
max-interval=<sec>
Defines the value in seconds in which actualization of the name in the DNS database must occur. 2073600
seconds (24 days) is the default value. The shortest interval allowed is 60 seconds. Bear in mind that this
setting may cause the provider to block the domain name, since multiple registrations in short intervals are
often not allowed. You must clear this with your provider.
[DynDNS]
service=dyndns
user=user:pwd
host=host.domain.de
interface=pppoe0
max-interval=2073600
Table 7.7 pabx.cfg: DynDNS (continued)
DynDNS Parameters
To Next Page
Loading...
