TELES ECOTEL - Fixed LAIN for a Mobile Port; Incoming Voice Calls from Mobile; Blocking Ports

MOBILE CONFIGURATION OPTIONS
CHAPTER 9
168
ECOTEL 3G 16.1. Revised: 2011.
route.cfg
9.3.3 FIXED LAIN FOR A MOBILE PORT
Enter
CHADDR[<addr>] to remove a mobile controller belonging to an LAIN group from the standard routing
process (e.g. for specific routes or only for SMS transmission). The port address can be set to
<addr>.
Example:
9.4 INCOMING VOICE CALLS FROM MOBILE
Incoming mobile calls (service indicator 01 represents voice calls) can be routed to a specified number. This enables
each mobile controller to receive a unique identifier. It will then be mapped to an FXS port:
The mobile controllers can also have the same identifier, so that all voice calls (service indicator 01) from controller
20 are sent to port 30. This number could, for example, serve a call center.
9.5 BLOCKING PORTS
This function allows you to block a port, so that the corresponding mobile channel is omitted from the distribution
of calls. The function is particularly useful when mobile channels fail or SIM cards cannot be immediately replaced.
To disable the port for outgoing calls enter the keyword
CHINC[01,01] in the Subscriber line and restart
the system.
In Example 1  , port 04 is blocked for outgoing calls.
To enable the port for outgoing calls, remove the entry and enter Activate Configuration.
...
MapAll01555=2621201555
...
MapAll01556=2621301556
...
Subscriber05=TRANSPARENT ROUTER UMTS[0000,00000,+49555,1,1,1,SIM4] CHADDR[444] ALARM
MapAllSMS=444 DATA
The value entered for <addr> may not exceed 6 digits.
Restrict20=30 01
Restrict21=31 01
Restrict20=30 01
i
i