SIGNALING AND ROUTING FEATURES
CHAPTER 8
157
ECOTEL 3G 16.1. Revised: 1 March 2011.
The keyword Restrict allows you to set a second modification in the OAD in the case of a redirect.
Example: In the first part of this example, OADs beginning with 030 are changed to 4930:
If the call is not connected and a Redirect3 is configured for the call, the OAD will be changed
from 4930 to 004930 as follows:
DAD
Enter one of the four specific number types in the DAD as follows:
MapAll<num>=<port><type><num>
In the case of a VoIP controller, enter the following:
MapAll<num>=<port><voip profile>:<type><num>
The number type will then be defined at the port. For the national and international types, remove the 0(s) at the
beginning of the number:
Example: In the following example, the international bit is set for all calls to Italy (
0039) and the number
is transmitted with
39. For the area code 012, the national bit is set and the number is trans-
mitted with
12:
8.7 SETTING THE SCREENING INDICATOR
You can set the screening indicator to define whether the calling-party number sent is specified as
user
provided verified and passed
or network provided:
User provided verified and passed:
v
Example: In the following Restrict example, the calling party number sent is specified as user
provided verified and passed
:
Network provided:
p
Example: In the following Restrict example, the calling party number sent is specified as network
Restrict
entries are handled from general to specific from top to bottom.
Restrict9030=4930 15
RestrictR4930=004930 15
MapAll0039=40iG1:i39 VOICE
MapAll012=40iG1:n12 VOICE
Restrict10=v 15
i
i
To Next Page
Loading...
