TELES ECOTEL - Routing Parameters

ADDITIONAL VOIP PARAMETERS
CHAPTER 14
227
ECOTEL 3G 16.1. Revised: 2011.
14.3 ROUTING PARAMETERS
Table 14.5 Customized Parameters: VoIP Routing
VoIP Basic Parameters
VoipOadMask=<num>
VoipDadMask=<num>
It is also possible to define the profile by destination or origination number (and not only by the IP address).
That means you can use different parameters not only for different IP addresses, but also for different num-
bers (e.g. other codec,
WaitForConnect, etc.). For example, you can define a number for the head of the
company, so that her MSN always uses G.711.
It is possible to configure a list of numbers for a total of up to 80 characters per line. You must define the
entry again if you need more numbers. You can also use a wildcard * at the end of the number to match all
calls with OADs or DADs beginning with the digits entered. Use a coma to separate the numbers. Example:
VoipDadMask=123, 345*, 567, ....,
VoipDadMask=912, 913*, 914, ....,
....
Bear in mind that you must enter numbers from global to specific (as for normal routing in the route.cfg).
That means you must enter a profile with more specific numbers below a profile with more global numbers.
VoipUseIpStack=<mode>
Enter
Yes to facilitate direct use of an xDSL or dial-up connection if the corresponding profile is defined.
Default is
No.
VoipUseEnum=<mode>
Enter
yes (default no) to activate an ENUM query to the called number before the call is set up via VoIP or
PSTN. Using a standard DNS query, ENUM changes telephone numbers into Internet addresses. If a number
is found, the call is set up via VoIP. If not, call setup occurs via PSTN or with another VoIP profile.
NOTE: The query must include country and area codes.
VoipEnumDomain=<string>
Use this parameter to modify the domain name for the enum query (default is
e164.arpa).
VoipUseStun=<mode>
Enter yes (default yes) to use the STUN values for the VoIP profile.
VoIPOwnIpAddress=<ip addr>
If the system is behind a NAT firewall that does not translate H.323 or SIP, the NAT firewall’s public IP address
is transmitted as own IP address in the H.323 or SIP protocol stack (not the private IP address). In this case,
the public IP address must be defined. Bear in mind that the NAT firewall transmits the ports for signaling
and voice data to the ECOTEL’s private IP address.