TELES ECOTEL - Setting Sending Complete Byte in Setup; Excluding Prefixes from Vgate Counter; Exclusion from SIM Daily Call Attempts Counter

SIGNALING AND ROUTING FEATURES
CHAPTER 8
159
ECOTEL 3G 16.1. Revised: 1 March 2011.
with 030, the call is sent through controller 10:
Use the entry
Restrict<port><oad>=<num> 15 if digits at the beginning of the OAD are the only ones to
be restricted.
Example: In the following example, the digits 004930 are replaced with 030 followed by the remaining
digits. The destination number begins with 030 and is sent through port 10.
8.9 SETTING SENDING COMPLETE BYTE IN SETUP
In some cases the ISDN or H323 peer system may require this byte for routing, or the byte may disrupt signaling.
Setting Sending Complete
The following entry ensures that the Setup includes a Sending Complete:
MapAll<direct>=)<num>
The ) causes inclusion of Sending Complete in the ISDN Setup or in the H323 Setup.
Example: In the following example, all calls beginning with 0 are sent with a Sending Complete to control-
ler 9:
Removing Sending Complete
The following entry ensures that the Setup never includes a Sending Complete:
MapAll<direct>=(<num>
The ( causes removal of Sending Complete in the ISDN Setup or in the H323 Setup.
Example: In the following example, all calls beginning with 0 are sent without a Sending Complete to VoIP
controller 40. The VoIP profile is
DF:
8.10 EXCLUDING PREFIXES FROM vGATE COUNTER
This option allows you to exclude flat rate prefixes (e.g. fixed network calls) from the vGATE and iGATE limit
counters.
8.10.1 EXCLUSION FROM SIM DAILY CALL ATTEMPTS COUNTER
The keyword CNC (call not counted) will exclude the mapping entry from the call counter:
Restrict9=*12345 15
MapAll030=10030
Restrict9004930=030 15
MapAll030=10030
MapAll0=)90
MapAll0=(40DF:0