SIGNALING AND ROUTING FEATURES
CHAPTER 8
156
ECOTEL 3G 16.1. Revised: 1 March 2011.
first part of the command and 19 in the second.
8.6 SETTING NUMBER TYPE IN OAD/DAD
In some cases it may be necessary to set a specific number type for the OAD or DAD. There are different methods
for the various interfaces. The following number types can be set:
OAD
Use the following entry to set a specific number type in the OAD:
Restrict<port><num>=<type> 15
For the national and international types, remove the 0(s) at the beginning of the number:
Restrict<port>0=n 15
Restrict<port>00=i 15
Example: In the following example, the bit is set in the caller’s origination number for a call via BRI con-
troller 01:
You can set a u (unknown type of number) in the Restrict entry to change transmission of the national/international
bit to 0 or 00 at the beginning of the OAD. As in a mapping entry, the national/international bit will always appear
left of the equal sign as 0 or 00.
Restrict<port>0=u0 15
Restrict<port>00=u00 15
Example: In the following example, the area code 030 with a 0 at the beginning of the OAD of the PBX’s
extension is set as a digit and transmitted along with the number:
...
MapAll015550123451=$Reception
MapAll015550123452=$Reception
MapAll015550123453=$Reception
MapAllReception=015559876543
Table 8.1 Number Types
Type Definition
uUnknown
s Subscriber number
n National number
i International number
Restrict90=n 15
Restrict900=i 15
Restrict10555=u030555 15
To Next Page
Loading...
