TELES ECOTEL - Deactivating Mobile Rerouting

MOBILE CONFIGURATION OPTIONS
CHAPTER 9
177
ECOTEL 3G 16.1. Revised: 2011.
9.12 DEACTIVATING MOBILE REROUTING
The following entries in the
pabx.cfg enable you to deactivate rerouting for rejected calls:
WND2N
Suppresses voice detection after WIND:2 is received.
Module Q24xx only.
MINA[<count>]
Defines the number of alert tones that are required before an Alert is recognized.
REDIAL[<per-
cent>,
<waitmin>,
<waitmax>,
<callingmin>,
<callingmax>,
<connectmin>,
<connectmax>,
<cfg>]
Repeats a call to the same B-party number as soon as the A party hangs up. This
parameter is useful for improving call statistics:
 Percent: Percentage of calls (including alert only) through the gateway
that are redialed.
 Waitmin: Minimum number of seconds the gateway waits before redial.
 Waitmax: Maximum number of seconds the gateway waits before redial.
 Callingmin: Minimum number of seconds the gateway waits before call
setup for redial. We recommend no more than 8 seconds.
 Callingmax: Maximum number of seconds the gateway waits before call
setup for redial. We recommend no less than 15 seconds.
 Connectmin: Minimum connect time (in seconds) if call is connected.
 Connectmax: Maximum connect time (in seconds) before call is
disconnected.
 Cfg: Enter a value 1 – 4; valid for the
UMTS1= line to UMTS4= line.
CPSA[0|1]
When CPSA ist set to 0, the GSM port is forced to register the SIM card to it’s home
network, which is identified by the first 5 or 6 digits of the IMSI. This may result in
a faster registration process.
CPSA[1] is the default value.
AllClassNext=<mode>
Enter AllClassNext=Off to deactivate rerouting for all rejected calls, regardless of the cause value (default not
configured).
NOTE: You cannot configure both
AllClassNext and Class2Next simultaneously!
Class2Next=off
Enter Class2Next=Off to deactivate rerouting for calls rejected with a class 2 cause value (default not
configured).
NOTE: You cannot configure both
AllClassNext and Class2Next simultaneously!
Table 9.1 Optional Mobile Parameters (continued)
UMTS=...