TELES ECOTEL - Registrar Profiles

CONFIGURATION FILES
CHAPTER 5
86
ECOTEL 3G 16.1. Revised: 1 March 2011.
5.3.4 REGISTRAR PROFILES
Registrar profiles are used to register the ECOTEL with a SIP registrar. It is possible to configure different registrars
for different destinations and to define backup registrars. These registrar profiles are then assigned to the VoIP
profiles:
Table 5.25 route.cfg: Registrar Parameters
Registrar Parameters
[Registrar=<name>]
The name of the registrar profile.
RegId=<name or ip addr>
Host name or IP address used in the register’s request header. Bear in mind that the DNS service must be
active if you enter the host name.
RegOwnId=<name@ip addr/domain>
Typically a host name or telephone number followed by an @ sign and a domain name or IP address. The
entry used in the
From: field. The default setting is RegUser@RegId.
RegSameCallID=<mode>
When Yes is set (default), the same caller ID is always used for SIP registration. Set No to change the caller
ID for each SIP registration.
RegContact=<name or ip addr>
Used in the
Contact: field.
RegContactParam=<string>
Sets additional header-parameters in the contact field (e.g.the q-value: RegContactParam=q=1.0).
RegUser=<name>
Enter a username for authorization.
RegPwd=<password>
Enter a password for authorization.
RegProxy=<ip addr>
Enter an alternative IP address if you want the request to be sent to an address other than the one entered
in
RegId.
RegExpires=<sec>
Enter the number of seconds registration is to be valid. Default
0 means infinite.
RegPing=<sec>
Interval (in seconds) for the registrar ping. The ECOTEL sends an empty UDP packet to the registrar’s IP ad-
dress. The packet is essentially an alive packet to avoid possible firewall problems.