TELES ECOTEL - Page 85

CONFIGURATION FILES
CHAPTER 5
85
ECOTEL 3G 16.1. Revised: 1 March 2011.
GkPwd=<name>
Password to log onto the gatekeeper. If you do not use authentication, leave this entry blank.
GkAdd=<ip addr>
The gatekeeper’s IP address.
GkTtl=<sec>
Gatekeeper time to live (default 0 means infinite).
GkMaxChan=<count>
Max. number of channels used for this gatekeeper. If this parameter is not defined (default), there will be no
limit.
GkDynMaxChan=<mode>
The static number of available channels in the gatekeeper profile (
GkMaxChan=<count>) is replaced with
a dynamic number of active mobile ports (up to the number entered in
GkMaxChan) when Yes is entered
here. Default is
No.
GkUseStun=<mode>
Enter
yes (default) to use the STUN values for the GK profile.
GkTerminalAliasWithPrefix=<mode>
Some gatekeepers may require that prefixes are listed in the Terminal Alias section. Enter
Yes to activate
this function; default value is
No).
GkTerminalTypeWithPrefix=<mode>
Enter
no to deactivate sending the Dialed Prefix Information in the Registration Request (default yes).
GkDynRai=<mode>
When yes is entered, the GK receives an RAI (resource availability indication) when a status change occurs
on the available mobile channels. When no is entered, the RAI is sent with each ARQ (admission request)
and DRQ (disengaged request). Default is no.
GkNoResourceAvailableIndication=<mode>
With this parameter the <system> will not send RAI indications to the Gatekeeper. Default No.
Table 5.24 route.cfg: Gatekeeper Parameters (continued)
Gatekeeper Parameters