TELES ECOTEL - Radius Profiles

CONFIGURATION FILES
CHAPTER 5
87
ECOTEL 3G 16.1. Revised: 1 March 2011.
5.3.5 RADIUS PROFILES
Radius profiles are used to connect the ECOTEL to a Radius server. You can use a Radius server for different des-
tinations and for access and/or accounting. These Radius profiles are then assigned to the VoIP profiles:
RegSignalling=<int>
Determines the profile’s signaling protocol for registration with the SIP registrar.
1=SIP udp (default)
2=SIP tcp
3=SIP tls
RegUseReceived=<mode>
Enter Yes when an ECOTEL appears behind a NAT and STUN cannot be used. Default No.
RegSameCallID=<mode>
The same call ID is used for SIP registration Enter No to change the call ID for every reregistration. (default
Yes).
Table 5.26 route.cfg: Radius Parameters
Radius Parameters
[Radius=<name>]
The name of the Radius server profile assigned to one or more VoIP profiles.
Host=<name or ip addr>
Radius server’s host name or IP address. Bear in mind that the DNS service must be active if you enter the
host name.
User=<name>
Enter a username for authorization.
Password=<password>
Enter a password for authorization.
Secret=<secret>
Enter the shared secret.
OwnId=<name or ip addr>
Host name or IP address used in the NAS identifier or NAS IP address (Cisco VSA gateway ID).
ServiceType=<num>
As defined in RFC 2865, Chapter 5.6.
Table 5.25 route.cfg: Registrar Parameters (continued)
Registrar Parameters