CONFIGURATION FILES
CHAPTER 5
61
ECOTEL 3G 16.1. Revised: 1 March 2011.
5.2.1.5 SUBSCRIBERS
Features for each port can be defined using this entry. Changes become active following a restart:
You must restart the system after making changes to activate the settings.
Table 5.15 pabx.cfg: Subscriber Parameters
Subscriber<port>=<list>
<port>
Refers to the running (physical) port number.
The <list> variable may contain one or more of the following keywords:
DEFAULT
The standard configuration will be used.
TRANSPARENT ROUTER
Only the number is sent as caller ID (without the virtual port address). Acti-
vate configuration suffices to activate changes. If TRANSPARENT ROUTER is
not set, the address of the incoming port is added to the A party number as
a prefix.
ALARM
Activates the monitoring mode for the respective port. If a relevant error oc-
curs at the port, the error is written in the protocol.log file. Depending on
the configuration, a remote connection to the number defined for AlarmCall-
back is established and/or an SNMP trap is generated. Activate configura-
tion suffices to activate changes.
SWITCH
Changes internal port handling. In the default configuration, the VoIP con-
troller is set to NT. You can use this parameter to change it from NT to TE.
CHMAX[x]
Defines the number of VoIP channels (8) or DTMF channels. A maximum of
two concurrent channels are possible for DTMF recognition if the callback
platform is used.
CHADDR
UMTS controllers only: Changes the controller definition to the SIM card’s
LAIN.
To Next Page
Loading...
