TELES ECOTEL - Redirect

CONFIGURATION FILES
CHAPTER 5
78
ECOTEL 3G 16.1. Revised: 1 March 2011.
5.3.1.3 REDIRECT
This entry facilitates alternative routing when the first destination cannot be reached or is busy. A placeholder ap-
pears to the right of the equal sign. The routing entry (
MapAll) can be defined for the redirect using the place-
holder entered:
Table 5.21 route.cfg: Redirect Parameters
Redirect<type><num>=<redirect> <sin> <time>
Parameter Desription No. Digits Optional
<type>
Enter 2 or 3 to set the following types:
2 call forwarding no answer
3 call forwarding when busy
1
<num>
Defines the number for which calls will be redirected. The
special symbol
? may be used as a wildcard to represent
any character.
59
<redirect>
Defines the placeholder used in the two-target routing
entry and the number to which calls to
<x> will be redi-
rected.
59
<sin>
The service indicator variable sin restricts the command to
a service. Without a sin, the
Redirect command is val-
id for all services.
Possible service indicator values are:
00 All services
01 Telephony
02 Analog services
03 X.21-services
04 Telefax group 4
05 Videotext (64 kbps)
07 Data transfer 64 kbps
08 X.25-services
09 Teletex 64
10 Mixed mode
15 Videotext (new standard)
16 Video telephone
NOTE: Fax forwarding must be set for analog
and telephony services because incoming fax
calls from the analog network may arrive with
either telephony or analog service indicators.
2(X)
(Only op-
tional if
<time> is
not set. If
<time> is
set and
<sin> is
not need-
ed please
select 00
for sin.)