TELES ECOTEL - Page 79

CONFIGURATION FILES
CHAPTER 5
79
ECOTEL 3G 16.1. Revised: 1 March 2011.
Example: In the following example all international calls (beginning with 00) are sent to VoIP controller
40 with the carrier profile DF. If the carrier cannot be reached or is busy, the redirect command
activates the second target mapping with the placeholder
A and the call is automatically sent to
controller
20.
Example: In the following example, calls to 20 that remain unanswered for 12 seconds and calls to 21 that
remain unanswered for 20 seconds are redirected through the PSTN port.
Excluding Busy Calls or Specific Cause Values from Redirect
Defines a hexadecimal cause value according to DSS1. When connections to the destination are rejected because
of the reason defined by the cause value, the ECOTEL sends a busy signal to the attached PBX. Alternative routing
is not carried out.
To avoid second-choice routings when the called-party number is busy, set the following parameter in the first-
choice port’s
Subscriber line in the pabx.cfg:
Example: In the following example, all outgoing calls over controller 04 are rejected with the cause value
<time> For type 2 redirect entries, a timer (in seconds) can be de-
fined after the service indicator entry.
255 X
MapAll00=40DF:00
Redirect340DF:=A
MapAllA=20
MapAll01555=|2001555<<13
MapAll01556=|2101556<<13
Redirect220=A 01 12
Redirect221=A 01 20
MapAllA=9
BUSY[<cause>]
Defines a hexadecimal cause value according to DSS1. When connections to the
destination are rejected because of the reason defined by the cause value, the
ECOTEL sends a busy signal to the attached PBX. Alternative routing is not car-
ried out. You can also define a range of consecutive cause values:
BUSY[<cause>,<cause>].
An exclamation point (!) in front of a cause value means all cause values except
the one listed. For example,
BUSY[!95], means all cause values except 95 will
be rejected with a busy signal.
Table 5.21 route.cfg: Redirect Parameters (continued)
Redirect<type><num>=<redirect> <sin> <time>
Parameter Desription No. Digits Optional