TELES ECOTEL - Global Settings

CONFIGURATION FILES
CHAPTER 5
67
ECOTEL 3G 16.1. Revised: 1 March 2011.
5.2.1.6 GLOBAL SETTINGS
This category contains the following system parameters:
Table 5.18 pabx.cfg: IP Configuration System Parameters
System Parameters
VoipGlobalMaxChan=<count>
Max. number of channels for the entire system.
VoipMaxChanOut=<count>
Limits outgoing calls through this profile. You have to define the number of VoIP channels to be used.
VoipSuppressRtcp=<mode>
Suppresses (
Yes) or allows (No) the sending of RTCP packets.
VoipAnnounce=<filename>
Defines an audio file which is played to the A-leg for calls for which the B-Leg is sent through this profile
after the start of the B-Leg (INVITE or h323-setup).
VoipStopAnnounceOnConnect=<mode>
If
Yes is set and the call changes to the state CONNECTED, the announcement configured with VoipAn-
nounce is stopped.
VoipStopAnnounceOnAlert=<mode>
If
Yes is set and the call changes to the state ALERTING, the announcement configured with VoipAnnounce
is stopped.
DialBackStopOnConnect=<mode>
Deletes (
On) the dialback record once a dialback call is connected. Off deactivates this behavior.
VoipFaxVolume=<volume>
Defines the volume of fax and CID tones.
Range: 0 (-21 dB) to 15 (-6 dB)
Default: 9 (-12 db)
VoipCEDTransferMode=<int>
Defines whether CED (a tone initially sent by a fax device) is sent via T.38 or RTP:
0 = T.38 (default)
1 = RTP
VoipCngRelayEnable=<int>
Defines whether CNG (a tone initially sent by a fax device) is transmitted by means of T.38 or RTP:
0 = RTP (default)
1 = T.38