TELES ECOTEL - Page 221

ADDITIONAL VOIP PARAMETERS
CHAPTER 14
221
ECOTEL 3G 16.1. Revised: 2011.
VoipIgnoreDADType=<mode>
Enter
yes to change the DAD type to unknown, e.g. from international. The type is lost, e.g. the leading 00
bit is removed. Default
no.
VoipSuppressInbandInfoAvailableIndicatorInCallProceeding
=<mode>
Enter
yes to send or receive the Progress Indicator in the Q.931 Call Proceeding message. Default no.
VoipG72616PayloadType=<num>
Changes the SIP payload type for G.726 16 b/s. Default is 35. A common value is 102.
VoipG72624PayloadType=<num>
Changes the SIP payload type for G.726 24 b/s. Default is 36. A common value is 99.
VoipTrpPayloadType=<num>
Defines the payload type for data calls when trp (transparent/clear mode) is used as codec in
VoipCompression=<list>. Default is 56. A common value is 102.
VoipDataBypassPayloadType=<num>
Defines the payload type for the RTP packets when the call is sent as a data call. Default 96.
VoipMinDigitOnTime=<ms>
Defines the minimum length of DTMF tones, to ensure DTMF tone detection. Default 0.
VoipMinInterDigitTime=<ms>
Sets a time interval for DTMF tone detection. Default 0.
VoIPEarlyVP=<mode>
Activates the vocoder chip caused by an incoming SIP 180 or 183 without sdp. Fax tones coming from ISDN
are already recognized before the connect and can thus prepare or even allow a switch to T38. Default
no.
VoIPEarlyT38=<mode>
Enter
yes to enable T38 before the call has been connected. Enter no to enable T38 after the call has been
connected. Default yes.
Table 14.1 Customized Parameters: Protocol-Independent VoIP Signaling (continued)
Protocol-Independent VoIP Signaling Parameters