TELES ECOTEL - Page 233

ADDITIONAL VOIP PARAMETERS
CHAPTER 14
233
ECOTEL 3G 16.1. Revised: 2011.
VoipQualityCheck=<type minsamples limit recovertime>
type
Enter one of the following:
ASR1, ASR2, RoundTripDelay, Jitter or FractionLost
When type is ASR1 or ASR2:
minsamples
Minimum number of calls for which ASR shall be calculated with:
limit
A value between 0 and 100
recovertime
Seconds to block the profile.
When type is RoundTripDelay:
minsamples
Minimum number of seconds RTD must be above:
limit
The highest acceptable value for RTD (in milliseconds)
recovertime
Seconds to block the profile.
When type is Jitter:
minsamples
Minimum number of seconds jitter must be above:
limit
The highest acceptable value for jitter (in milliseconds)
recovertime
Seconds to block the profile.
When type is FractionLost:
minsamples
Minimum number of seconds FL must be above:
limit
The highest acceptable value for FL (percentage between o and 100)
recovertime
Seconds to block the profile
NOTE: If you base
VoipQualityCheck on the ASR values: During setup, calls are calculated as
not connected, which lowers the number of connected calls.
Example: If
minsamples is set at 20, with a limit of 80%, 4 calls in the setup phase will lower the ASR
of the previous 20 calls to 80% and the profile will be blocked.
VoipECE=<mode>
Enter yes (default) to set ITU G. 168 echo cancellation. Enter no to disable echo cancellation.
Table 14.6 Customized Parameters: VoIP Quality (continued)
VoIP Quality Parameters