CONFIGURATION FILES
CHAPTER 5
51
ECOTEL 3G 16.1. Revised: 1 March 2011.
Example:
Table 5.9 Settings in the [xppp] Section of the ip.cfg
[xppp<num>]
Dad=<num>
Enter the dial-up number.
User=<username>
Enter a username.
Pwd=<password>
Enter a password.
Route=<ip-addr>
Enter the target IP address range, e.g. 0.0.0.0 (default route).
Enter
chap (default) or pap for the protocol used for authentication.
AutoUp=<int>
Defines if the PPP interface is activated automatically after system start. The following values are possible:
0 = No automatic PPP activation (default)
1 = Automatic PPP activation
IdleTO=<sec>
Enter the number of seconds without traffic before the interface tears down the connection.
MTU=<int>
Maximum Transfer Unit. We recommend the following default values:
1500 for ISDN or 120 for mobile dial-up.
Rfc1662=<val>
Framing to be use:
0 for ISDN or 1 for mobile.
[xppp0]
Dad=12345
User=user
Pwd=pwd
Route=0.0.0.0
AuthProto=chap
IdleTO=60
MTU=120
Rfc1662=1
To Next Page
Loading...
