CONFIGURATION FILES
CHAPTER 5
59
ECOTEL 3G 16.1. Revised: 1 March 2011.
Ports set to the same type can have the same address. In this case they will form a trunk group. If you change this
parameter in the configuration, you must restart the system.
<type>
Defines the connection type:
TE external (Terminal Endpoint). All TE ports must be configured together
starting with port 1 on the left.
NT internal (Network Termination). All NT ports must be configured together
to the right of the TE ports.
VOIP VoIP module
DTMF virtual controller for activating DTMF tone recognition
<mode>
Defines the protocol for BRI lines:
DSS1
<line_type>
Defines Point-to-Multipoint or Point-to-Point mode:
PMP Point-to-Multipoint
PP Point-to-Point
UNIT:<unit>
(Optional) Defines the currency for the charges (default EUR). Special charge generation
is possilbe for:
France
UNIT:&F
Spain UNIT:&SP
Portugal UNIT:&P
Greece UNIT:&G
Switzerland
UNIT:&CH
Netherlands
UNIT:&NL
Italy UNIT:&I
NOTE: The <line_type> must be configured for these entries to work.
EXAMPLE:
Controller02=10 NT DSS1 PMP UNIT:€ VALUE:0.010
Controller03=10 NT DSS1 PMP UNIT:€ VALUE:0.010
VALUE:<value>
(Optional) Defines the charges that accumulate for each unit (default 12).
AUTOUP
For TE-ports only: keeps ISDN layer 2 active all the time.
Table 5.14 pabx.cfg: Controller Parameters (ECOTEL 3G BRI only)(continued)
Controller<port>=<address> <type> <mode> <line_type> FCT UNIT:<unit> VALUE:<value>
AUTOUP
To Next Page
Loading...
