TELES ECOTEL - Page 82

CONFIGURATION FILES
CHAPTER 5
82
ECOTEL 3G 16.1. Revised: 1 March 2011.
Please refer to Chapter 8  for information on other possible entries.
VoipMaxChan=<count>
Maximum number of channels that can be used with the profile. If this parameter is not defined (default),
there will be no limit.
NOTE: For versions 13.0c or lower, we recommend that you also set the parameter
VoipDelayDisc to Yes to improve the ASR.
VoipSilenceSuppression=<mode>
Yes activates silence suppression, CNG (comfort noise generation) and VAD (voice activity detection). No
(default) deactivates silence suppression.
NOTE: In SIP signaling, silence suppression is negotiated as per RFC3555.
VoipTxM=<num> or <list> fix
The multiplication factor (1-12) for the frame size for transmission of RTP packets (default is 4). 10ms is the
default frame size. A list can be defined if different frame sizes are to be used for different codecs in the VoIP
profile. The list must correspond with the list in the parameter
VoipCompression.
Normally the peer’s frame size will be used if it is smaller than the one defined. If you enter
fix, the config-
ured factor will always be used.
Table 5.22 route.cfg: VoIP Basic Parameters (continued)
VoIP Basic Parameters