AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page120of233
#RFSTS – Read current network Status in 3G network
Parameter LTE Example description
PLMN "262 25" Country code and operator code(MCC, MNC)
EARFCN 6400 E-UTRA Assigned Radio Channel
RSRP -99 Reference Signal Received Power
RSSI -76 Received Signal Strength Indication
RSRQ -7 Reference Signal Received Quality
TAC 40A5 Tracking Area Code
TXPWR 0 Tx Power (In traffic only)
DRX 64 Discontinuous reception cycle Length(cycle length :
display using ms)
MM 19 Mobility Management
RRC 0 Radio Resource Control
CID 0000007 Cell ID
IMSI “262011242110776” International Mobile Station ID
NetNameAsc " Telekom.de " Operation Name, Quoted string type or “” if network
name is unknown
SD 3 Service Domain
(0: No Service, 1: CS only, 2: PS only, 3: CS+PS)
ABND 20 Active Band (1..63) 3GPP TS 36.101
SINR 93 Signal-to-Interface plus Noise Ratio
(range 0 - 250)
Note: nSAT - Number of active set, Maximum is 6.
Note: If nSAT value is 1, it means that active set number 1. Module does not display after
parameters of nSAT.
Note: TXPWR of GSM network means 1 tx burst
Note: MM - Mobility Management States are:
0 - NULL
3 - LOCATION_UPDATE_INITIATED
5 - WAIT_FOR_OUTGOING_MM_CONNECTION
6 - CONNECTION_ACTIVE
7 - IMSI_DETACH_INITIATED
8 - PROCESS_CM_SERVICE_PROMPT
9 - WAIT_FOR_NETWORK_COMMAND
10 - LOCATION_UPDATE_REJECTED
13 - WAIT_FOR_RR_CONNECTION_LU
14 - WAIT_FOR_RR_CONNECTION_MM
15 - WAIT_FOR_RR_CONNECTION_IMSI_DETACH
17 - REESTABLISHMENT_INITIATED
18 - WAIT_FOR_RR_ACTIVE
To Next Page
Loading...
Need help?
General
