Telit Wireless Solutions ME910C1 Series Reference Guide






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page226of233

<slp_address>: SLP address in FQDN format, IPv4 or IPv6
format
Note: The current setting is stored in NVM.
Note:
This parameter also update during AT$SLP set
command
AT$SLPTYPE?
Read command returns the current SLP address type.
AT$SLPTYPE=?
Test command returns the range of values for parameter
$SLPTYPE: (0-1, 3)
Set the User Plane Secure Transport - $SUPLSEC
$SUPLSEC – Set the User Plane Secure Transport
AT$SUPLSEC=
<option>
Set command configures the User Plane Secure Transport
Parameter:
<option >: Integer type
0 - Disable User Plane Secure Transport(UPL)
1 - Enable User Plane Secure Transport(SUPL)
AT$SUPLSEC?
Read command returns the currently used values,
in the format:
$SUPLSEC: < option >
AT$SUPLSEC=?
Test command returns the supported range of values of parameters < option >
$SUPLSEC: (0-1)
Example
AT$SUPLSEC =1
OK
AT$SUPLSEC?
$SUPLSEC:1
OK
Configure SUPL TLS and Hash - $SUPLCFG
$SUPLCFG – Configure SUPL TLS and Hash
AT$SUPLCFG
=[<tls>],[<hash
>]
This command permits to configure the SUPL TLS and Hash algorithm version.
Parameters:
<tls >:
0 – Use TLS v.1.0 (default)
1 – Use TLS v.1.1
<hash >:
0 – Use SHA-1 (default)
1 – Use SHA-256

Telit Wireless Solutions ME910C1 Series Specifications

General

Brand	Telit Wireless Solutions
Model	ME910C1 Series
Category	Wireless modules
Language	English