Telit Wireless Solutions ME910C1 Series Reference Guide






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page28of233

&P - Default Reset Full Profile Designation
Parameter:
<n>
0...1 – profile number: the wireless module is able to store 2 full configurations (see
command &W).
Note: differently from command Z<n>, which loads just once the desired profile, the
one chosen through command &P will be loaded on every startup.
Note: if parameter is omitted, the command has the same behaviour as AT&P0
Reference
Telit Specifications
Manufacturer Identification - +GMI
+GMI - Manufacturer Identification
AT+GMI
Execution command returns the manufacturer identification.
Reference V.25ter
Model Identification - +GMM
+GMM - Model Identification
AT+GMM
Execution command returns the model identification.
Reference
V.25ter
Revision Identification - +GMR
+GMR - Revision Identification
AT+GMR
Execution command returns the software revision identification.
Reference
V.25ter
Serial Number - +GSN
+GSN - Request Product Serial Number Identification
AT+GSN
Execution command returns the device board serial number.
Note: The number returned is not the IMSI, it is only the board number.
Reference V.25ter

Telit Wireless Solutions ME910C1 Series Specifications

General

Brand	Telit Wireless Solutions
Model	ME910C1 Series
Category	Wireless modules
Language	English