AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page155of233
PAD forward character - #PADFWD
AT#PADFWD?
Read command reports the currently selected <char> and <mode> in the format:
#PADFWD: <char>,mode
AT#PADFWD=?
Test command reports the supported range of values for parameters <char> and
<mode>.
Feature PAD currently applicable for UART only
P
AD command features - #PADCMD
PAD command features - #PADCMD
AT#PADCMD=
<mode>
This command sets features of the pending data flush to socket, opened with
AT#SD command.
Parameters:
<mode>:
Bit 1:
1 - enable forwarding;
0 – disable forwarding;
Other bits reserved.
Note: forwarding depends on character defined by AT#PADFWD
AT#PADCMD?
Read command reports the currently selected <mode> in the format: #PADCMD:
mode
AT#PADCMD=?
Test command reports the supported range of values for parameter <mode>.
Feature PAD currently applicable for UART only
Socket Configuration Extended - #SCFGEXT
#SCFGEXT - Socket Configuration Extended
AT#SCFGEXT=
<connId>,
<srMode>,
<dataMode>,
<keepalive>
[,<ListenAutoRsp>[
,<sendDataMode>
]]
Set command sets the socket configuration extended parameters.
Parameters:
<connId> - socket connection identifier
1..6
<srMode> - SRing URC mode
0 - normal mode (default):
SRING : <connId>
where:
<connId> - socket connection identifier, as before
1 - data amount mode:
SRING : <connId>,<recData>