AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page26of233
3.4
AT Commands References
3.4.1
Command Line General Format
3.4.1 Command Line Prefixes
Starting a Command Line - AT
AT - Starting A Command Line
AT
The prefix AT, or at, is a two-character abbreviation (ATtention), always used to
start a command line to be sent from TE to TA
Reference
3GPP TS 27.007
Last Command Automatic Repetition - A/
A/ - Last Command Automatic Repetition
A/
If the prefix A/ or a/ is issued, the MODULE immediately executes once again the
body of the preceding command line. No editing is possible and no termination
character is necessary. A command line may repeated multiple times through this
mechanism, if desired.
If A/ is issued before any command line has been executed, the preceding command
line is assumed to have been empty (that results in an OK result code).
Note: this command works only at fixed IPR.
Note: the custom command #/ has been defined, it causes the last command to be
executed again too; but it does not need a fixed IPR.
Reference
V25ter
To Next Page
Loading...
Need help?
General
