AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page171of233
Context Activation and Configuration - #SGACTCFG
#SGACTCFG - Context Activation and Configuration
Execution command is used to enable or disable the automatic
activation/reactivation of the context for the specified PDP context, to set the
maximum number of attempts and to set the delay between an attempt and the next
one. The context is activated automatically after every GPRS Attach or after a NW
PDP CONTEXT deactivation if at least one IPEasy socket is configured to this
context (sees AT#SCFG).
Parameters:
<cid> - a numeric parameter which specifies a particular PDP context definition
(see +CGDCONT command)
<retry> - numeric parameter which specifies the maximum number of context
activation attempts in case of activation failure. The value belongs to the
following range: 0 - 15
0 - disable the automatic activation/reactivation of the context (default)
<delay> - numeric parameter which specifies the delay in seconds between an
attempt and the next one. The value belongs to the following range: 180 - 3600
<urcmode> - URC presentation mode
0 - disable unsolicited result code (default)
1 - enable unsolicited result code, after an automatic activation/reactivation, of
the local IP address obtained from the network. It has meaning only if <auto>=1.
The unsolicited message is in the format:
#SGACT: <ip_address>
Reporting the local IP address obtained from the network.
Note: the URC presentation mode <urcmode> is related to the current AT instance
only. Last <urcmode> setting is saved for every instance as extended profile
parameter, thus it is possible to restore it even if the multiplexer control channel is
released and set up, back and forth.
Note: <retry> and <delay> setting are global parameter saved in NVM
Note: if the automatic activation is enabled on a context, then it is not allowed to
modify by the command AT#SCFG the association between the context itself and
the socket connection identifier; all the other parameters of command AT#SCFG
are modifiable while the socket is not connected
AT#SGACTCFG=
<cid>,
<retry>,
[,<delay>
[,<urcmode>]]
Read command reports the state of all the five contexts, in the format:
#SGACTCFG: <cid1>,<retry1>,<delay1>, < urcmode >CR><LF>
…
AT#SGACTCFG?
To Next Page
Loading...
Need help?
General
