Telit Wireless Solutions ME910C1 Series Reference Guide






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page82of233

+CSDH - Show Text Mode Parameters
+CSDH: <show>
AT+CSDH=?
Test command reports the supported range of values for parameter <show>
Reference
3GPP TS 27.005
Save Settings - +CSAS
+CSAS - Save Settings
AT+CSAS[=
<profile>]
Execution command saves settings which have been made by the +CSCA, +CSMP
and +CSCB commands in local non-volatile memory.
Parameter:
<profile>
0 - it saves the settings to NVM (factory default).
1..n - SIM profile number; the value of n depends on the SIM(le9x0 allow to store
up to 5).
Note: certain settings may not be supported by the SIM. Therefore, the settings
always saved to the NVM, regardless the value of <profile>.
Note: If parameter is omitted the settings are saved in the non-volatile memory.
AT+CSAS=?
Test command returns the possible range of values for the parameter <profile>.
Reference
3GPP TS 27.005
Restore Settings - +CRES
+CRES - Restore Settings
AT+CRES[=
[<profile>]
Execution command restores message service settings saved by +CSAS command
from either NVM or SIM.
Parameter:
<profile>
0 - it restores message service settings from NVM.
1..n - it restores message service settings from SIM. The value of n depends on the
SIM (le9x0 allow to store up to 5).
Note: certain settings may not be support by the SIM and therefore they are always
restored from NVM, regardless the value of <profile>.

Telit Wireless Solutions ME910C1 Series Specifications

General

Brand	Telit Wireless Solutions
Model	ME910C1 Series
Category	Wireless modules
Language	English