AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page70of233
+CGACT - PDP Context Activate Or Deactivate
Note: if no <cid>s are specified, the activation form of the command activates at
least the first three defined contexts. The deactivation form deactivates all the active
contexts.
AT+CGACT?
Read command returns the current activation state for all the defined PDP contexts
in the format:
+CGACT: <cid>,<state>[<CR><LF>+CGACT: <cid>,<state>[…]]
AT+CGACT=?
Test command reports information on the supported PDP context activation states
parameters in the format:
+CGACT: (0,1)
Example AT+CGACT=1,1
OK
AT+CGACT?
+CGACT: 1,1
OK
Reference 3GPP TS 27.007
PDP Context Modify - +CGCMOD
+CGCMOD action command syntax
AT+CGCMOD=
[<cid>
[,<cid>
[,…]]]
It has no effect and is included only for backward compatibility with landline modems
Possible Response(s):
OK
ERROR
The execution command used to modify the specified PDP context (s) with repect to
QoS profiles and TFTs. After
command has completed, the MT returns to V.250 online data state. If the requested
modification for any specified context cannot be achieved, an ERROR or +CME
ERROR response is returned. Extended error responses are enabled by the +CMEE
command.
For EPS, the modification request for an EPS bearer resource will be answered by the
network by an EPS bearer
Modification request. The request must be accepted by the MT before the PDP context
effectively changed.
If no <cid>s are specified the activation form of the command modifies all active
contexts.
The test command returns a list of <cid>s associated with active contexts.
Defined Values
<cid>: a numeric parameter which specifies a particular PDP context definition (see
the +CGDCONT and
+CGDSCONT commands).
To Next Page
Loading...
Need help?
General
