AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page182of233
FTP AT Commands
FTP Time – Out - #FTPTO
#FTPTO - FTP Time-Out
AT#FTPTO=
[<tout>]
Set command sets the time-out used when opening either the FTP control
channel
or the FTP traffic channel.
Parameter:
<tout> - time-out in 100 ms units
100..5000 - hundreds of ms (factory default is 100)
Note: The parameter is not saved in NVM.
AT#FTPTO?
Read command returns the current FTP operations time-out, in the format:
#FTPTO: <tout>
AT#FTPTO=?
Test com
and returns the
an
e of su
o
ted
alues
FTP Open - #FTPOPEN
#FTPOPEN - FTP Open
AT#FTPOPEN=
[<server:port>,
<username>,
<password>,
<mode>]
Execution command opens an FTP connection toward the FTP server.
Parameters:
<server:port> string type, address and port of FTP server (factory default port
21), in the format:
“ipv4” / “ipv4:port”
“ipv6” / “[ipv6]” / “[ipv6]:port”
“dynamic_name” / “dynamic_name:port”
<username> string type, authentication user identification string for FTP.
<password> string type, authentication password for FTP.
<mode>
0 - active mode (factory default)
1 - passive mode
Note: In FTP Open case, the solution dependency limits the maximum time out to
To Next Page
Loading...
Need help?
General
