Telit Wireless Solutions ME910C1 Series Reference Guide






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page62of233



Commands for GPRS
GPRS Attach or Detach - +CGATT
+CGATT - GPRS Attach Or Detach
AT+CGATT=
[<state>]
Execution command used to attach the terminal to, or detach the terminal from, the
GPRS service depending on the parameter <state>.
Parameter:
<state> - state of GPRS attachment
0 - detached
1 - attached
AT+CGATT?
Read command returns the current GPRS service state.
AT+CGATT=?
Test command requests information on the supported GPRS service states.
Example
AT+CGATT?
+CGATT: 0
OK
AT+CGATT=?
+CGATT: (0,1)
OK
AT+CGATT=1
OK
Reference
3GPP TS 27.007
GPRS Event Reporting - +CGEREP
+CGEREP - GPRS Event Re
p
ortin
g
AT+CGEREP=
[<mode>[,<bfr>]]
Set command enables or disables sending of unsolicited result codes +CGEV:
XXX (see below) from TA to TE in the case of certain events occurring in the TA
or the network.
Parameters:
<mode> - controls the processing of URCs specified with this command
0 - Buffer unsolicited result codes in the TA. If TA result code buffer is full, the
oldest one can be discarded. No codes are forwarded to the TE.

Telit Wireless Solutions ME910C1 Series Specifications

General

Brand	Telit Wireless Solutions
Model	ME910C1 Series
Category	Wireless modules
Language	English