AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page221of233
nfo>,<location_type>,< nav_profile>,< velocity_request>
AT$GPSQOS=?
Returns the list of supported QoS values for each field.
$GPSQOS: (0-1800000),(0-990),(0-14400),(0-1966020),(0-
2),(0-3),(0,1)
Example
AT$GPSQOS=1800000,990,150,0,0,0
OK
Note
The current setting is stored through $GPSSAV
GPS Start Location Service Request-$GPSSLSR
$GPSSLSR – GPS Start Location Service Request
$GPSSLSR=<transport_p
rotocol>[,<pos_mode>[,<c
lient_id>,<clientid_type>[
,<mlc_number>,<mlcnum
ber_type>[,<interval>[,<s
nym_indicator>],<error_
mask>
]]]]]]
Command used to start the Receiver in Autonomous or A-
GPS mode. Parameters:
<transport_protocol>:
0 - CPlane
1 - SUPL
2 – Invalid
Note: If <pos_mode > is Autonomous the
<transport_protocol> should be invalid.
Note: If <transport_protocol> is CPlane and
<pos_mode > is Pure MS Assisted, then
<interval> should be 0 (or omitted).
<pos_mode>:
0: Pure MS Assisted - Location estimate from the network
(MS Assisted mode).
1: MS Based - Assistance Data from the network (MS Based
mode).
2: Not Supported.
3: Autonomous – Autonomous GPS mode of operation.
Note: If <pos_mode> is Autonomous the
<transport_protocol> should be invalid.
<client_id>:
String parameter containing the ID of the LCS-Client to which
the location estimate is to be transferred.
Note: Max length is 64 bytes.
Note: <client_id> is mandatory in case of A-GPS and
the <transport_protocol> should be Cplane.
Note: LE9x0 don't support <client_id> setting because of not
supporting the 3rd Part Location Transfer.
<clientid_type>:
0 – MSISDN
1 – Invalid (default)
To Next Page
Loading...
Need help?
General
