AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page29of233
Display Current Base Configuration and Profile - &V
&V - Display Current Base Configuration And Profile
AT&V Execution command returns some of the base configuration parameters
settings.
DTE - Modem Interface Control
Command Echo - E
E - Command Echo
ATE[<n>]
Set command enables/disables the command echo.
Parameter:
<n>
0 - Disables command echo
1 - Enables command echo (factory default), hence command sent to the device echo
back to the DTE before the response is given.
Note: if parameter is omitted, the command has the same behaviour of ATE0
ATE?
Read command returns the current value of n.
Reference
V25ter
Quiet Result Codes - Q
Q - Quiet Result Codes
ATQ[<n>]
Set command enables or disables the result codes.
Parameter:
<n>
0 - enables result codes (factory default)
1 - disables result codes
2 - disables result codes
(only for backward compatibility)
To Next Page
Loading...
Need help?
General
