Telit Wireless Solutions ME910C1 Series Reference Guide






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page56of233

+CESQ – Extended Signal Quality
34 - -3 dB  rsrq
255 - not known or not detectable detectable or if the current serving cell is not a
EUTRA cell
<rsrp> - reference signal received power (see 3GPP TS 36.133 subclause 9.1.4).
0 - rsrp < -140 dBm
1 - -140 dBm  rsrp < -139 dBm
2 - -139 dBm  rsrp < -138 dBm
...
95 - -46 dBm  rsrp < -45 dBm
96 - -45 dBm  rsrp < -44 dBm
97 - -44 dBm  rsrp
255 not known or not detectable detectable or if the current serving cell is not
a EUTRA cell
AT+CESQ=?
Test command returns the supported range of values of the parameters <rxlev>,
<ber>, <rscp>, <ecno>, <rsrq>, <rsrp>.
Reference 3GPP TS 27.007
Mobile Equipment Event Reporting - +CMER
+CMER - Mobile Equipment Event Reporting
AT+CMER=
[<mode>
[,<keyp>
[,<disp>
[,<ind>
[,<bfr>]]]]]
Set command enables/disables sending of unsolicited result codes from TA to TE in the
case of indicator state changes (n.b.: sending of URCs in the case of key pressings or
display changes are currently not implemented).
Parameters:
<mode> -
controls the processing of unsolicited result codes
0 - discard +CIEV Unsolicited Result Codes.
1 - discard +CIEV Unsolicited Result Codes when TA-TE link is reserved (e.g. on-line
data mode); otherwise forward them directly to the TE.
2 - buffer +CIEV Unsolicited Result Codes in the TA when TA-TE link is reserved
(e.g. on-line data mode) and flush them to the TE after reservation; otherwise
forward them directly to the TE.
3 - forward +CIEV Unsolicited Result Codes directly to the TE; when TA is in on-line
data mode each +CIEV URC is replaced with a Break (100 ms), and is stored in a
buffer; onche the ME goes into command mode (after +++ was entered), all URCs
stored in the buffer will be output.
<keyp> - keypad event reporting
0 - no keypad event reporting
<disp> - display event reporting
0 - no display event reporting
<ind> - indicator event reporting
0 - no indicator event reporting
2 - indicator event reporting
<bfr> - TA buffer clearing

Telit Wireless Solutions ME910C1 Series Specifications

General

Brand	Telit Wireless Solutions
Model	ME910C1 Series
Category	Wireless modules
Language	English