AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page43of233
+IMEISV - Serial and Software Version Number
PCCA STD-101 Select Wireless Network - +WS46
+WS46 - PCCA STD-101 Select Wireless Network
AT+WS46=[<n>]
Set command selects the cellular network (Wireless Data Service, WDS) to
operate with the TA (WDS-Side Stack Selection).
Parameter:
<n> - integer type, it is the WDS-Side Stack to be used by the TA.
12 - GSM Digital Cellular Systems (GERAN only)
28 E-UTRAN only
30 GERAN and E-UTRAN
Note: <n> parameter setting is stored in NVM and available at next reboot.
Note: 4G only products support <n> parameter value 28 only.
Note: 4G/2G only products support <n> parameter values 12, 28 and 30 only. 30
is factory default
Note: for NA (North America) products supporting AT&T requirement 13340
about RAT Balancing and EF-RAT Mode, the value <n> stored with AT+WS46
command can be changed and overwritten in case of full SIM read (e.g.: power on,
AT+CFUN=4/AT+CFUN=1 sequence, SIM ejection/SIM insertion sequence).
AT+WS46?
Read command reports the currently selected cellular network, in the format:
+ WS46: <n>
AT+WS46=?
Test command reports the range for the parameter <n>.
Reference 3GPP TS 27.007
Network Service Handling
Subscriber Number - +CNUM
+CNUM - Subscriber Number
AT+CNUM
Execution command returns the MSISDN (if the phone number of the device has
been stored in the SIM card) in the format:
+CNUM:
<alpha>
,<number>,<type>[<CR><LF> +CNUM:
<alpha>
,<number>,<type>[…]]
To Next Page
Loading...
Need help?
General
