Telit Wireless Solutions ME910C1 Series Reference Guide






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page64of233

+CGEREP - GPRS Event Reporting
+CGEREP: <mode>,<bfr>
AT+CGACT=?
Test command reports the supported range of values for the +CGEREP command
parameters.
Reference 3GPP TS 27.007
GPRS Network Registration Status - +CGREG
+CGREG - GPRS Network Registration Status
AT+CGREG=[<n>]
Set command controls the presentation of an unsolicited result code
+CGREG: (see format below).
Parameter:
<n> - result code presentation mode
0 - disable network registration unsolicited result code
1 - enable network registration unsolicited result code; if there is a change in the
terminal GPRS network registration status, it is issued the unsolicited result
code:
+CGREG: <stat>
where:
<stat> - registration status
0 - not registered, terminal is not currently searching a new operator to register
to
1 - registered, home network
2 - not registered, but terminal is currently searching a new operator to register
to
3 - registration denied
4 - unknown
5 - registered, roaming
2 - enable network registration and location information unsolicited result code; if
there is a change of the network cell, it is issued the unsolicited result code:
+CGREG: <stat>[,<lac>,<ci>[,<AcT>,<rac>]]
where:
<stat> - registration status (see above for values)
<lac> - Local Area Code (when <AcT> indicates value 0
to 6) or tracking area code (when <AcT> indicates value 7)
<ci> - cell ID in hexadecimal format.
<AcT>: access technology of the registered network:
0 GSM
2 UTRAN
3 GSM w/EGPRS

Telit Wireless Solutions ME910C1 Series Specifications

General

Brand	Telit Wireless Solutions
Model	ME910C1 Series
Category	Wireless modules
Language	English