Telit Wireless Solutions ME910C1 Series Reference Guide






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page63of233

+CGEREP - GPRS Event Reporting
1 - Discard unsolicited result codes when TA-TE link is reserved (e.g. in on-line
data mode); otherwise forward them directly to the
TE.
2 - Buffer unsolicited result codes in the
TA when TA-TE link is reserved (e.g. in
on-line data mode) and flush them to the
TE when TA-TE link becomes available;
otherwise forward them directly to the
TE.
<bfr>
- controls the effect on buffered codes when <mode> 1 or 2 is entered:
0 -
TA buffer of unsolicited result codes defined within this command is cleared
when
<mode>=1 or 2 is entered.
1 -
TA buffer of unsolicited result codes defined within this command is flushed to
the
TE when <mode>=1 or 2 is entered (OK response shall be given before
flushing the codes)
Unsolicited Result Codes
The following unsolicited result codes and the corresponding events are defined:
+CGEV: REJECT <PDP_type>, <PDP_addr>
A network request for PDP context activation occurred when the
TA was unable to
report it to the
TE with a +CRING unsolicited result code and was automatically
rejected
+CGEV: NW REACT <PDP_type>, <PDP_addr>, [<cid>]
The network has requested a context reactivation. The <cid> that was used to
reactivate the context is provided if known to
TA
+CGEV: NW DEACT <PDP_type>, <PDP_addr>, [<cid>]
The network has forced a context deactivation. The <cid> that was used to activate
the context is provided if known to
TA
+CGEV: ME DEACT <PDP_type>, <PDP_addr>, [<cid>]
The mobile equipment has forced a context deactivation. The <cid> that was used
to activate the context is provided if known to
TA
+CGEV: NW DETACH
The network has forced a GPRS detach. This implies that all active contexts have
been deactivated. These are not reported separately
+CGEV: ME DETACH
The mobile equipment has forced a GPRS detach. This implies that all active
contexts have been deactivated. These are not reported separately
+CGEV: ME CLASS <class>
The mobile equipment has forced a change of MS class. The highest available class
is reported (see
+CGCLASS)
AT+CGEREP?
Read command returns the current <mode> and <bfr> settings, in the format:

Telit Wireless Solutions ME910C1 Series Specifications

General

Brand	Telit Wireless Solutions
Model	ME910C1 Series
Category	Wireless modules
Language	English