Telit Wireless Solutions ME910C1 Series Reference Guide






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page67of233

+CGPIAF - Printing IP Address Format
at+CGPIAF=1,0,0,0
OK
AT#SGACT=1,1
#SGACT: FC01:ABAB:CDCD:EFE0:0:0:0:1
OK
Reference
3GPP TS 27.007
Define PDP Context - +CGDCONT
+CGDCONT - Define PDP Context
AT+CGDCONT=
[<cid>
[,<PDP_type>
[,<APN>
[,<PDP_addr>
[,<d_comp>
[,<h_comp>
[,<pd1>
[,…[,pdN]]]]]]]]]
Set command specifies PDP context parameter values for a PDP context identified by
the (local) context identification parameter <cid>.
Parameters:
<cid> - (PDP Context Identifier) numeric parameter which specifies a particular PDP
context definition.
1..max - where the value of max is returned by the Test command.
<PDP_type> - (Packet Data Protocol type) a string
parameter which specifies the type of packet data
protocol.
"IP" - Internet Protocol
"PPP" - Point to Point Protocol
“IPV6” - Internet Protocol, Version 6
“IPV4V6” - Virtual <PDP_type> introduced to handle dual IP
stack UE capability.
<APN> - (Access Point Name) a string parameter which is a
logical name that is used to select the GGSN or the
external packet data network. If the value is null or
omitted, then the subscription value will be requested.
<PDP_addr> - a string parameter that identifies the
terminal in the address space applicable to the PDP. The
allocated address may be read using the +CGPADDR command.
<d_comp> - numeric parameter that controls PDP data
compression.
0 - off (default if value is omitted)
1 – on
2 - V.42bis
<h_comp> - numeric parameter that controls PDP header
compression.
0 - off (default if value is omitted)
1 – on
2 - RFC1144 (applicable for SNDCP only)
3- RFC2507
4- RFC3095 (applicable for PDCP only)

Telit Wireless Solutions ME910C1 Series Specifications

General

Brand	Telit Wireless Solutions
Model	ME910C1 Series
Category	Wireless modules
Language	English