Telit Wireless Solutions ME910C1 Series Reference Guide






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page230of233

<cid> - a numeric parameter which specifies a particular PDP
context definition (see +CGDCONT command)
Note: <cid> is mandatory if <mode> is set to lock, otherwise
shall be omitted.
Note: the set command returns ERROR if the current cid and/or
the previously set are in use. Note: The current setting is stored
in NVM.
AT$LCSLK?
Read command returns the current value of parameters <mode>
and
<cid> (if <mode> is lock).
AT$LCSLK=?
Test command returns the range of values for parameters
<mode> and <cid>
Clear GPS Data - $GPSCLRX
$GPSCLRX – Clear GPS Data
AT$GPSCLRX
This command resets all of the parameters related with GPS
Resets all parameters related with GPS as following:
- GPS Almanac Data
- GPS Ephemeris Data
- LBS User Plane PDE IP Address
- LBS User Plane PDE IP Port
Note: This command is global and cannot clear individual pieces
of data.
AT$GPSCLRX =?
Test command returns the OK result code
Example
AT$GPSCLRX=?
OK
AT$GPSCLRX
OK

Telit Wireless Solutions ME910C1 Series Specifications

General

Brand	Telit Wireless Solutions
Model	ME910C1 Series
Category	Wireless modules
Language	English