AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page222of233
Note: <client_id> and <clientid_type> are mandatory
for A-GPS mode.
<mlc_number>: String parameter containing the address of
the GMLC through which the location estimate is to be sent to
the LCS-Client.
Note: <mlc_number> is mandatory in case of A-GPS.
<mlcnumber_type>:
0 – MSISDN
1 – Invalid (default)
Note: <mlc_number> and <mlcnumber_type> are
mandatory for A-GPS mode.
<interval>:
0 - 7200: GPS reporting period in seconds (will be sent unsolicited).
if the value is 0 then a single shot NMEA Message will be
provided. Any value different from 0 sets the period (in seconds)
between each NMEA Sentence.
Note: If this value is not set, it is assumed to be 0.
Note: The Unsolicited NMEA sentences have to be enabled with
the commands AT$GPSNMUN.
<service_type_id>:
0 - 255 where 255 indicates that this parameter shall not be used.
Note: <service_type_id> is mandatory in case of A-GPS.
<pseudonym_indicator>:
0 FALSE (default) : display user name at the external client.
1 TRUE : display user name as anonymous at the external client
<error_mask>:
0 - 4294967295: If certain bit is set, respective error code becomes
non-abortable.
Note: If this value is not set, it is assumed to be 0.
If C-plane or Supl session is not successfully completed, it will be
stopped and unsolicited indication reports the error cause in the
following formats:
$GPSSLSR: SUPL/C-PLANE ERROR,<error_code>
where
<error_code>
0 - Phone Offline
1 - No servcie
2 - No connection with PDE
3 - No data available
4 - Session Manager Busy
5 - Phone is CDMA locked
6 - Phone is GPS locked
7 - Connection failure with PDE
To Next Page
Loading...
Need help?
General
