AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page124of233
<otlz>: Operate low zone temperature threshold. Default
value -28°C.
<otlz_act_in >: Operate low zone action info. Default value 0.
<
otnz_clr>: Operate normal zone temperature threshold clear.
Default value -30°C.
<otnz>: Operate normal zone temperature threshold.
Default value 95°C.
<otnz_act_in>: Operate normal zone action info. Default value
0.
<
otuz_clr>: Operate up zone temperature threshold clear.
Default value 93°C.
<otuz>: Operate up zone temperature threshold. Default
value 100°C.
<otuz_act_in>: Operate up zone action info. Default value 3.
<
etuz_clr>: Extreme up zone temperature threshold clear.
Default value 98°C.
<etuz>: Extreme up zone temperature threshold. Has only
one valid value: 528°C.
see notes
<etuz_act_in
>: Extreme up zone action info. Default value 3.
See notes for detailed description of thermal mitigation
configuration.
AT#TEMPCFG?
Read command reports the current parameter setting for
#TEMPCFG command in the format:
#TEMPCFG:
<etlz_clr>,<etlz>,<etlz_act_in>,<otlz_clr>,<otlz>,<otlz_act_i
n>,<otnz_clr>,<otnz>,<otnz_act_in>,<otuz_clr>,<otuz>,<otu
z_act_in>,<etuz_clr>,<etuz>,<etuz_act_in>
AT#TEMPCFG =?
Test command reports the supported range values for parameters
<x
_clr>,<x>,<x_action_info>.
Where "x" is substitute for "
etlz", "otlz", "otnz", "otuz", "etuz".
Values are:
#TEMPCFG: (-40-100),(-40-100),(0-5)
Notes:
After setting new values, there must be an execution of power cycle or #REBOOT command in order for the
mitigation algorithm to operate with them.
Thermal mitigation mechanism works like this:
• The whole temperature scale is divided into 5 states (zones).
• Each measured temperature should be belonging to a particular state called the "
current state".
State is defined by the following fields:
- "
thresholds" – upper temperature boundary of the state. Values are in °C.
To Next Page
Loading...
Need help?
General
