Telit Wireless Solutions ME910C1 Series Reference Guide






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page52of233

+CPIN - Enter PIN
<code> is returned only when the last executed command
resulted in PUK2 authentication failure
(i.e.
+CME ERROR: 18)
PH-NET PIN - ME is waiting network personalization
password to be given
PH-NET PUK - ME is waiting network personalization
unblocking password to be given
PH-NETSUB PIN - ME is waiting network subset
personalization password to be given
PH-NETSUB PUK - ME is waiting network subset
personalization unblocking password to be given
PH-SP PIN - ME is waiting service provider
personalization password to be given
PH-SP PUK - ME is waiting service provider
personalization unblocking password to be given
PH-CORP PIN - ME is waiting corporate personalization
password to be given
PH-CORP PUK - ME is waiting corporate personalization
unblocking password to be given
Note: Pin pending status at startup depends on PIN facility setting, to change or query
the default power up setting use the command
AT+CLCK=SC,<mode>,<pin>
Example
AT+CMEE=1
OK
AT+CPIN?
+CME ERROR: 10 error: you have to insert the SIM
AT+CPIN?
+CPIN: READY you inserted the SIM and device is not waiting for PIN to be
given
OK
Note
What follows is a list of the commands which are accepted when ME is pending SIM
PIN or SIM PUK
A &K +CPIN
D +GCAP +CSQ
H &P +GCI +CIND
O +IPR +CMER
E &V +IFC +CCLK
I &W +ILRR +CALA
L +ICF
M +CRSM
P +DS
Q +DR
+CGMI

Telit Wireless Solutions ME910C1 Series Specifications

General

Brand	Telit Wireless Solutions
Model	ME910C1 Series
Category	Wireless modules
Language	English