AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page85of233
+CNMI - New Message Indications To Terminal Equipment
to network immediately when +CSMS <service> is set
to '0' or when +CSMS <service> is set to '1', acknowledge is sent via +CNMA
command during predefine time-out, an error is sent to network in case timeout expire,
Next +CMT response is depend on acknowledge of current received +CMT response
in case +CSMS <service> parameter set to '1'.
3 - Class 3 SMS-DELIVERs are routed directly to TE using unsolicited result codes
defined in
<mt>=2. Messages of other data coding schemes result in indication
as defined in
<mt>=1.
<bm> - broadcast reporting option
0 - Cell Broadcast Messages are not sent to the
DTE
2 - New Cell Broadcast Messages are sent to the
DTE with the unsolicited result
code:
(PDU Mode)
+CBM: <length>
<CR><LF><PDU>
where:
<length> - PDU length
<PDU> - message PDU
(TEXT Mode)
+CBM:<sn>,<mid>,<dcs>,<pag>,<pags><CR><LF><data>
where:
<sn> - message serial number
<mid> - message ID
<dcs> - Data Coding Scheme
<pag> - page number
<pags> - total number of pages of the message
<data> - CBM Content of Message
If
<dcs> indicates that GSM03.38/23.038 default alphabet is used , each
character of GSM/WCDMA alphabet will be converted into current TE
character set (see +CSCS)
If
<dcs> indicates that 8-bit or UCS2 data coding scheme is used, each 8-
bit octet will be converted into two IRA character long hexadecimal
number (e.g. octet 0x2A will be converted as two characters 0x32 0x41)
<ds> - SMS-STATUS-REPORTs reporting option
0 - status report receiving is not reported to the
DTE and messages are stored
1 - the status report is sent to the
DTE with the following unsolicited result code:
(PDU Mode)
+CDS: <length><CR><LF><PDU>
where:
<length> - PDU length
<PDU> - message PDU
To Next Page
Loading...
Need help?
General
