Tenda V1200 - Page 38

28
----End
Parameter description
Parameter
Description
Connection Type

PPPoE (PPP over Ethernet), PPPoA (PPP over ATM): If your ISP (ISP) provides a user
name and password to you for internet access, your connection type may be PPPoE
or PPPoA, contact your ISP for details.

IPoE (IP over Ethernet) - Dynamic IP: Select this type if your ISP does not provide
any parameters to you for internet access.

IPoE (IP over Ethernet) - Static IP, IPoA (IP over ATM) - Static IP:If your ISP provides
a static IP address and other related information to you for internet access, your
connection type may be IPoE or IPoA, contact your ISP for details.

Bridge: Select this type when this device only serves as a modem, and you want to
set up a dial-up connection or enter other internet parameters directly on your
computer for internet access.
Encapsulation Mode
It specifies the data encapsulation type in the ATM network. LLC and VC/MUX are
supported. The default is recommended.
Service Category
It specifies the ATM QoS type assigned by the ISP. The default is recommended.