43
The WAN service you set is shown on the WAN Service page.
IPoE
Choose the corresponding procedure to follow according to your IP address type: IPv4 IPoE,
IPv4&IPv6 IPoE, and IPv6 IPoE.
IPv4 IPoE
Step 1 Choose Advanced Setup > WAN Service to enter the following page, and click Add.
Step 2 Select ATM interface you create on the Layer2 Interface page, which is atm0/(0_0_35) in
this example, and click Next.
Step 3 Select IP over Ethernet.
Step 4 Enter the 802.1P Priority and 802.1Q VLAN ID, and select the VLAN TPID according to the
VLAN parameters provided by your ISP.
Step 5 Select IPv4 Only and click Next.
To Next Page
Loading...
