EasyManuals Logo

Tenda V1200 User Manual

Tenda V1200
257 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
70
1. Choose Advanced Setup > WAN Service to enter the following page, and click Add.
2. Select the interface you create in Layer2 Interface, which is ptm0/(0_1_1) in this example,
and click Next.
3. Select a WAN service type according to the instructions in the table below. Here takes
PPPoE as an example.
4. Enter the 802.1P priority and 802.1Q VLAN ID parameters provided by your ISP.
If you are unsure about the 802.1P priority and 802.1Q VLAN ID parameters, refer to
Appendix A.3 VLAN List. If the parameters are not available, ask your ISP to provide it.
5. Select your network protocol type as required, and click Next. IPv4 is used to illustrate
here. Refer to Setting up a WAN Service for the ATM Interface for the instruction of other
network protocols.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tenda V1200 and is the answer not in the manual?

Tenda V1200 Specifications

General IconGeneral
BrandTenda
ModelV1200
CategoryNetwork Router
LanguageEnglish

Related product manuals